Important Information; Identification Of Parts; Date Of Manufacture; Assembling Your Stroller - Evenflo JourneyLite Instructions

IMPORTANT INFORMATION

Child Requirements
Maximum weight: 40 lbs (18 kg)
Maximum height: 38" (96 cm)
IMPORTANT: Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble
the stroller according to these instructions. DO NOT USE YOUR STROLLER UNTIL YOU HAVE READ AND UNDERSTOOD
THESE INSTRUCTIONS.
If you are missing parts, do not use stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) to order replacment parts.
Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal
information. To register your product, please complete and mail the card that came with it or visit our on-line registration at
https://plweb.evenflo.com/productreg.aspx.
For future reference, record the Model Number and Date of Manufacture below.
Model Number:

IDENTIFICATION OF PARTS

(2) Front Wheel Assembly
Rear Axle Assembly
(2) Hubcap (2) Clevis Pin
2

Date of Manufacture:

Child's Tray
Stroller (folded)
(2) Steel Washer (2) Rear Wheel
1
B
2
B
C
3
D
F
G
E
I
H
Begin assembly of the rear wheels and axle assembly by discarding all packaging.
Slide one wheel and a steel washer onto the axle
D E
wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the axle and make sure the brake
housings are facing the same direction. Note: An extra clevis pin and steel washer are included for your convenience.
H
Install the hub cap I on the wheel by lining up the notch
completely until it snaps into place. Repeat on the other side.

ASSEMBLING YOUR STROLLER

Place the folded stroller on the floor so the parent's
A
handle B is visible on top.
Unfold the stroller by unlocking the fold latch
grabbing the parent's handle B and pulling upward.
Make sure stroller locks in the open position with audible
clicks.
C
E
G
G
F
K
J
I
. Insert a clevis pin through the end of the axle
F G
J with the tallest rib K in the wheel hub. Insert the hub cap
, then
C
to secure the
F
3