AUTO-HAK O69A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
6
B
8
9
8
5
This towing hitch is designed to assembly in following cars:
TOYOTA HILUX 2WD, small wheels, produced since 2005, catalogue
no. O69A and is prepared to tow trailers max total weight 2500 kg and max
vertical mass 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
A
6
B
1
7
15
3
4
From manufacturer
1. Disassemble a bumper together with handles.
2. From bumper disassemble the handles and put distance plates
8
(pos. 4) under. Reassemble.
9
3. To outside of the chassis frame fix loosely side brackets (pos.
5
5) through hole A using bolts M12x40mm (pos. 8). Use nut on
8
jib (pos. 6). Through hole B fix using bolts M12x1,25x40mm
(pos. 9).
4. Reassemble bumper loosely.
5. Between installed brackets (pos. 5) put main bar of the towing
hitch (pos. 1) and fix using bolts M12x40mm (pos. 8).
6. Fix body of the automat (pos. 15) and the socket plate (pos. 3)
using bolts M12x25mm (pos. 7) from accessories. Place tow-
4
ball (pos. 2) according to supplied instruction.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
9. Complete paint layer damaged during installation.
2
After install the towing hitch you should get adequate note in
registration book (at authorised service station). The car should be
equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must
be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE