Emerson InSinkErator Indulge Serie Manuel Du Propriétaire page 7

Electric Shock Hazard: Using an ungrounded or improperly connected
appliance can result in serious injury or death from electrical shock.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has a
grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances. Do not modify the plug
provided with the appliance – if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Check with a qualified electrician or serviceman if you are in doubt as to whether the instant hot
water dispenser is properly grounded.
Personal Injury: This tank is a non-pressurized tank. DO NOT modify this system.
DO NOT close vent tube or connect other type dispensers or valves to the tank. Use only
the InSinkErator dispenser faucet supplied. Use only parts provided. Contact an
authorized InSinkErator Service agent for repairs or replacement components.
Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as
rags, paper or aerosol cans near the tank. DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
Property Damage: To avoid water damage, replace any loose or split tubing.
Periodically inspect the unit for any signs of leakage and immediately remove from
service any unit suspected of leaking.
An instant hot water dispenser, like any water heater, has a limited life and will eventually fail.
To avoid possible property damage and personal injury, this instant hot water dispenser
should be regularly examined for leakage and/or corrosion and replaced when necessary. A
drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used
in those applications where any leakage could cause property damage. To check for
corrosion, examine the appearance of the dispensed water in a clear glass once every three
(3) months. If there is any discoloration or rusty appearance, unplug and drain unit as
described in the Seasonal Storage/Drainage section on page 13 of this manual. If the water
discoloration remains after draining and refilling unit, discontinue use and contact an
authorized InSinkErator service agent.
WARRANTY INFORMATION
Dispenser: 5-year warranty
Stainless Steel Tank: 3-year warranty
Filtration System: 1-year warranty (excluding replaceable filter cartridge)
Covers all replacement parts and labor to correct defects in material or workmanship in the
dispenser system, excluding the replaceable filter cartridge, for the full warranty period from the
date of installation in your home. If warranty service is required during the warranty period,
contact an authorized InSinkErator service agent to replace or repair the unit in your home at no
cost to you. If your dispenser is replaced rather than repaired, the warranty on the new unit
shall be for the duration of the remaining portion of the original dispenser's warranty. Note:
Warranty is determined by unit serial number and/or date of installation. Purchase or installation
receipt may be required to verify warranty status. When service is required, and for the location
of your nearest factory authorized service center, call toll free 1-800-558-5700.
The foregoing warranty does not apply to damage or inoperation resulting from accident,
alteration, misuse, abuse, improper installation, installation not in accordance with these
instructions or local electrical and/or plumbing codes. We do not assume any responsibility for
consequential damage. Install using genuine InSinkErator
Use of non InSinkErator components will void your warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the
exclusion or limitations of incidental or consequential damages, so the above limitations or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
12
® manufactured components only.
CARE AND USE
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
ADJUSTING THE THERMOSTAT
Factory temperature pre-set is
approx. 200°
200˚F. To reset the thermostat to
200°, turn the indicator two
notches to the right of vertical.
I I
Adjust the thermostat
slowly, turning the dial
clockwise to increase
temperature or counter
clockwise to decrease temperature, then
activate faucet handle for 20 seconds to
bring in fresh water to be heated at the
new setting. Allow 5-7 minutes for water
to reach new temperature.
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
SEASONAL STORAGE/DRAINAGE
Anytime the instant hot water dispenser is not used
for extended periods of time, unplug and drain unit. If
it is below freezing you will need to unplug the unit
and drain it.
I I
Disconnect power from unit.
I I
Push hot water dispenser faucet lever and
allow water to flow until it is cool.
I I
Shut the cold water supply off at the valve.
I I
Locate and remove drain screw from
bottom center of water tank and drain the
water into empty pail.
I I
Empty the tank and then reinstall drain
screw into the bottom of tank, turning
until snug. Do NOT over tighten.
I I
Remove and discard filter cartridge.
I I
To put back into working order, install new
filter cartridge, fill tank with water and
reconnect the electrical cord. (Refer to
Page 11, Step 6B)
PROPERTY DAMAGE
I I
Regularly inspect the unit for any signs of
leakage. If there are signs of water
damage, immediately remove the unit
from service.
I I
To avoid water damage from leakage,
replace all cut, loose or split tubing.
I I
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications
where any leakage could cause
property damage.
FILTER GUIDE AND REPLACEMENT
Replace filter cartridge when there is an obvious
decrease in water flow to the faucet or if there is an
objectionable taste or odor to the water.
When the inlet and outlet ports have been closed
and the filter's internal pressure has been relieved,
water (about 2 oz) will discharge from vent line.
If the new filter cartridge cannot be inserted, insert
the old one and turn until it stops, remove it and then
retry the new cartridge.
Carbon filters should be replaced within 12 months.
Filter replacement instructions:
I I
Replace with an InSinkErator ® filter.
I I
Place pan or dish towel under the filter to
catch water drainage during change.
I I
Slowly turn the cartridge counter-clockwise
completely until it stops (1/4 turn).
I I
Pull cartridge straight down and discard.
I I
Insert new cartridge into filter head.
I I
Top surface of cartridge will become flush
with the bottom of the filter head when
fully engaged.
I I
Turn the cartridge clockwise until it stops
(1/4 turn).
I I
Align the in/out arrow on the head and
bracket assembly to the in/out arrow on
the cartridge.
I I
Open faucet to expel trapped air.
I I
Run water for 3 minutes before usage.
CLEANING THE FAUCET AND TANK
I I
Only use mild cleaners to clean the faucet
and plastic components.
I I
Cleaners with acids, abrasives, alkaline or
organic solvents will result in deterioration
of the plastic components and void the warranty.
PERSONAL INJURY
I I
Regularly check for signs of corrosion
by examining the appearance of the
dispensed water.
I I
If there is any discoloration or rusty
appearance, unplug and drain unit
as described in the Seasonal
Storage/Drainage section on this
page of the manual.
I I
If the water discoloration remains after
draining and refilling unit, discontinue use
and contact an authorized InSinkErator
service agent.
13