Other Information; Programming The Remote Control - Sony KP-46WS510 Mode D'emploi

Other Information

Programming the Remote Control

The remote control is preset to operate Sony brand video equipment.
Sony
Equipment
Beta, ED Beta VCRs
8 mm VCR
VHS VCR
DVD Player
If you have video equipment other than Sony brand that you want to control
with the projection TV's remote control, use the following procedures to
program the remote control.
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
From the "Manufacturer's Codes" listed on page 73, select the three-digit
code number for the manufacturer's code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
Open the panel of the remote control.
2
Press inside the panel.
CODE SET
3
Close the panel and press
4
Enter the three-digit manufacturer's code number using the
5
Press .
ENTER
6
To check if the code number works, aim the projection TV's remote
control at the component and press the green
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
Switch Position
on Remote Control
AV1
AV2
AV3
DVD
SAT/CABLE (FUNCTON)
Programmable
Code Number
303
302
301
751
.
buttons.
0-9
button that
POWER
71