5. Press the START/CANCEL button to
activate this setting. The button surround
will illuminate red, the oven alert will sound,
and the LCD screen will illuminate orange.
6. The LCD screen will indicate a blinking
'PREHEATING'. Once the oven has reached
the set temperature, the temperature
alert will sound.
WHEN AT
7. Place food on the Breville enamel baking
pan or in an oven-proof pan, then place
on the center of the wire rack so air flows
around the back, as well as the front of
the food.
NOTE
It may be necessary to lightly grease or line
the enamel baking pan with baking paper to
prevent cookies from sticking.
Caution should be exercised when using metal
foil to cover accessories, pans, and dishes.
Be sure that the metal foil is fitted securely as
close contact with the oven's heating elements
can cause overheating and risk of fire.
When using metal foil to cover accessories,
pans, and dishes, it is recommended that the
wire rack be in the middle or bottom location.
Caution should be exercised when using pans
and dishes constructed of materials other
than metal. If using ceramic or glass pans or
dishes it is important that they are oven safe to
prevent cracking.
32
TEMP.
Caution should be exercised when using lids in
the oven, as pressure build up in a covered pan
or dish may cause hot ingredients to expel or
the dish to crack.
8. After the PREHEATING alert has sounded,
the timer will automatically begin to count
down in one minute increments. The
temperature and time can be adjusted
during the baking cycle by turning the
TEMP/TIME dial. Toggle between
Temperature and Time by pressing the
TEMP/TIME button.
9. At the end of the cooking cycle, the oven
alert will sound three times, the START/
CANCEL button will cease to illuminate
and the LCD screen will illuminate blue.
IMPORTANT
The outer surface of the oven, including the
oven door, is hot during and after operation.
Always use protective hot pads or insulated
oven mitts when inserting, removing or
handling items from the oven.
10. The COOKIE cycle can be stopped at any
time by pressing the START/CANCEL
button. This will cancel the cycle.
The button surround illumination will go
out and the LCD screen will illuminate blue.