Chal-tec 10003655 Mode D'emploi page 13

Attention:
Before your first ride, familiarise yourself with the handlebar controls of the scooter while it
is in the '0' state. After you feel secure, put the device in the '1' state.
Accelerate / throttle grip
• The scooter has an adjustable accelerator
throttle grip.
• Turn the right handle slowly towards yourself
to add gas. As you turn the handle further,
the engine retrieves more power and the
speed increases.
• When you release the throttle grip, the
handle returns to its original position and
the engine will stop retrieving power, thus
gradually slowing the device.
Brakes
Brakes can be found on either side of the handlebar. Pull the lever to activate the front brake
(right lever) or the rear brake (left lever). First, take the scooter at a low speed in order to
get used to the action of the brakes and braking behaviour as you learn.
Mounting and dismounting
1. Before every ride, fold the stand.
2. Place both hands on the handlebars. First, set one foot on the front part of the stand
board at an angle.
3. Go gently into a crouch to lower your centre of gravity and stabilise your balance.
4. Once you add gas to accelerate, put your second foot on the stand board and find a
position that allows you to maintain the best balance.
5. Never jump onto the scooter, and accelerate and brake with caution. Leave the stand
board only after braking to an almost stationary position.
Handlebar and Operation
13