Publicité
Les langues disponibles
Les langues disponibles
Mount the handlebar
Snap in the two sides of the handlebar. Check
that the handlebar is firmly in place by vigo-
rously moving the handlebar up and down.
Saddle mounting (optional)
Put the lower seat post into
the
latching
connections.
Bolt the clamp securely.
Important instructions
• Ensure that the power supply voltage corresponds to the value indicated on the power supply.
The power supply can be operated with an alternating current of 220 - 240 V.
• Use an appropriate plug adapter if the plug does not fit into your socket. Insert the power cord
fully into the outlet.
• Do not pull on the cable. Do not bend the cable or place heavy objects on top of it.
• Do not handle the plug with wet hands.
• Hold the plug when pulling it out of the device.
• Do not use a damaged mains plug or a damaged socket.
• Install this unit so that the power cord may be disconnected from the mains socket if a problem
occurs.
Adjust the height of the seat
post by loosening the upper
clamp, bring the inner rod of
the saddle rod to a conveni-
ent height and then tighten
the clamp again.
Before First Use
●
Put the saddle on the
saddle rod and fasten it se-
curely with the help of the
side-lying
screws.
that the saddle is securely
fastened with strong up-
ward, downward and side-
ways movements. Tighten
the screws until they are
tight enough while still al-
lowing the saddle room to
move.
Check
11
Publicité
