Télécharger Imprimer la page

Speaka Professional SP-5682204 Mode D'emploi page 6

Jeu d'appareil pour transfert par radio hdmi 100 m

Publicité

Les langues disponibles

Les langues disponibles

Elimination of malfunctions
No picture
• Switch on all devices or connect the transmitter and receiver to the power supply.
• Perform the pairing operation.
• Reduce the distance between transmitter and receiver, change the location, or align the
antennas again.
• Select the correct input on the TV.
• Do not place any devices on the transmitter or receiver, and do not place any of the two
between other devices. That would significantly reduce the wireless range.
• Use high-quality HDMI cables.
• Disconnect the transmitter and receiver from the power supply for a few seconds.
Picture interferences, sound disruptions
• Reduce the distance between transmitter and receiver, and/or change the installation
location.
Playback device does not react to IR remote control
• Position the IR transmitter and IR receiver at another location or align them in a different way.
• The product is not compatible with the IR transmission protocol used by your IR remote
control.
• For test purposes, press and hold the button on your IR remote control longer than usual.
• The range of the IR receiver is approx. 5 m, the acceptance angle is 30° (±15°). If necessary,
align the IR receiver in a different way.
Maintenance and cleaning
• Before cleaning, disconnect the product from the connected devices and unplug the power
adapter from the power outlet.
• There are no components located inside the product you need to maintain. Never open/
dismantle the product.
• Under no circumstances use aggressive cleanings agents, cleaning alcohol or other chemical
solutions since these can penetrate the housing or impair functionality.
• To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much pressure
to the housing as this may cause scratch marks.
• You can easily remove dust using a long-haired, soft and clean brush.
Declaration of Conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that
this product conforms to the fundamental requirements and the other relevant regulations of
the directive 1999/5/EC.
The Declaration of Conformity for this product can be found at www.conrad.com.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household
waste.
At the end of its service life, dispose of the product in accordance with applicable
regulatory guidelines.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
a) Transmitter
Operating voltage ............................. 5 V/DC
Supported resolution ........................ up to 1080p (Full HD)
3D support ........................................ Yes
HDMI input ........................................ 1
HDMI output ..................................... 1
Radio frequency ............................... 5 GHz
Range ............................................... 100 m (open area)
Latency ............................................. <500 ms
Dimensions (W x H x D) ................... 128 x 25 x 82 mm
Weight .............................................. 170 g (with antennas)
b) Receiver
Operating voltage ............................. 5 V/DC
HDMI output ..................................... 1
Dimensions (W x H x D) ................... 128 x 25 x 82 mm
Weight .............................................. 170 g (with antennas)
c) Power adapter
Operating voltage ............................. 100 – 240 V/AC, 50/60 Hz
Output ............................................... 5 V/DC, 1 A
d) General
Antenna length ................................. 195 mm
Operating conditions ......................... 0 to +40 °C, 30 – 70 % RH
Storage conditions ........................... -20 to +60 °C, 10 – 90 % RH
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the
technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
V1_0316_02-ETS-Mkd

Publicité

loading

Ce manuel est également adapté pour:

1420551