Publicité
Mounting the handshower
3
Installation de la
douchette
handshower
rubber washer
rubber gasket
rubber washer
metal washer
chrome
hose
A. Insert the flangle with threaded rod onto
the hole on your deck. Secure with the tie
down kit (washer & nut) as shown. (Fig.5)
B. Insert the chrome hose onto the hole of
your base flange as shown.
C. Take the handshower and the chrome
hose, connect together with rubber washer.
Tighten firmly.
last revision: 02/19/2018
Hoses connecting
Installation du drain
mixer
base
flange
mix water
hose
metal nut
Fig.5
A. Take the extension hose and mount the
1/2" female end into the bottom of the
shank as shown. Connect the other end
of the extension hose to the 3/8" end of
the chrome hose. (Fig.6)
B. Next connect the mix water hose into
the side outlet of the shanks as shown.
C. Finally, connect the hot & cold flexible
hose to the water supply lines.
madison 86013
robinet de bain 3 morceaux avec douchette
Connection checks
Vérification des raccordements
A. When the connections are made, turn on
the mixer. Check all joints for leaks. Tighten
as needed.
B. Flush out both lines again before you
thread your aerator back into the spout.
C. Turn on the mixer and with the water
now running from the spout, pull up on
the diverter to verify that the water is now
shank
chrome
diverted properly to the hand shower.
hose
Now turn off the mixer and the spring
loaded diverter will return back to spout.
extension
Only use the diverter to divert from the
hose
spout to the hand shower. Do not divert
back and forth with the water running.
Use only as instructed.
hot & cold
water supply
Fig.6
5
3-piece tub filler with handshower
aquabrass.com
Publicité
