Toro TMC-424 Mode D'emploi page 10

Note: Each program can only have one assigned watering schedule format.
If either an Interval or Odd/Even schedule is currently set, it must be turned off
first to enable another format to be selected.
To Set Calendar Days:
1. Turn the Function Dial to the Calendar Days
2. Sunday will be displayed and selected to water indicated by the water
To remove the day from the schedule, press the
the No Water
3. Press the button to select the next day.
4. Repeat step 2 and 3 to schedule the remaining days of the week.
To Set Odd or Even Days:
1. Turn the Function Dial to the Odd/Even
3. Press the or
4. To exclude specific days from watering, press the
5. To exclude the day from the schedule, the
No Water icon.
6. Repeat steps 4 and 5 to exclude additional days. 1 to 7 days can be excluded.
To Set Interval Days:
1. Turn the Function Dial to the Interval Days
2. The current interval number (01 to 31) or Off (– – –) will be displayed.
The Cycle Length prompt will be displayed.
3. Press the or
Note: The Interval cycle length can be set from 01 (water every day) to 31 (water
once every 31 days). The Interval cycle starts at 01 and increases by 1 digit
each day. The watering day occurs when the selected Interval cycle length is
reached. To specify when the first watering day will occur, the current day within
the interval cycle is selected. For example, if a 04-day Interval is selected and
you want watering to begin in one day, set 03 as the Current Day.
4. To select the current day in the Interval cycle, press the
the or buttons to select from 01 (up to the selected interval number).
The Current Day prompt will be displayed.
5. To exclude specific days from watering, press the
6. To exclude the day from the schedule, the
No Water icon.
7. Repeat steps 5 and 6 to exclude additional days. 1 to 7 days can be excluded.
STOP – This concludes the basic program setup procedures. Repeat
these procedures starting at "Select the Program" on page 6 for each
additional program you wish use at this time.
8
icon.
buttons to select ODD or EVEN.
buttons to select an Interval number.
position.
or buttons to display
position.
button to select the day.
or buttons to display the
position.
button, then press
button to select the day.
or buttons to display the
icon.