Getting started
Control Lock You can lock the controls to prevent selections from being made. You can also lock the
controls after you have started a cycle to prevent cycle changes. For example, children cannot
accidentally start the dishwasher by pressing buttons with this option selected.
To LOCK the dishwasher control, press the Heated Dry and Wash Temp buttons for 3 seconds
and the lock indicator will appear on the display.
To UNLOCK the dishwasher control, press the Heated Dry and Wash Temp buttons for
3 seconds and the lock indicator will no longer appear on the display.
Start Dishwasher
Start
Interrupt
or Pause
Cancel
7
Restart Dishwasher
When the display shows the error codes, press the Delay Start and Cycles buttons at the
same time, the machine will be reset to power on state.
Cycle Indicator Lights and Sounds
8
Sanitized Indicator If the sanitize cycle was selected, sanitized indicator will be turn on at the end of the
cycle, if the NSF requirements for sanitization are not reached. The light will not turn on. Certified residential
dishwashers are not intended for licensed food establishments.
The sanitize cycle is NSF certified.
8
Close the door and press the Start button to start the cycle or begin the Delay Hours
countdown. The display will turn off if the machine keep standby state 15 minutes. To activate
the display, press any button.
To interrupt or pause a dish cycle, slowly open the door. To restart or resume the cycle, close
the door then press Start Cancel
To cancel a wash cycle, press and hold the Start Cancel button for 3 seconds . The
dishwasher will drain and display start to 60 seconds countdown. After draining ,emit a beep
sound, and the machine enter the standby state.
29-5953-2