Orbegozo DS 57190 B IN Mode D'emploi page 14

DS 57190 B IN
(5) NOTICE OF INSTALLATION
1. Before installation, please ensure the area is clean to avoid suction of the remaining bits of broken wood
and dust.
2. It cannot share the same air ventilation tube with other appliance such as gas tube, warmer tube, and
hot wind tube.
3. The bending of ventilation tube should be≥120°, parallel or above the start point and should be
connected to the external wall.
4. After installation, make sure that the extractor is level to avoid grease collection at one end.
(6) USE
Speed adjustment .See pictures
Push button
1. Push stop button, and the motor will stop.
2. Push the Low button, the buzzer will buzz once, and the motor runs at low speed.
3. Push the high button, the buzzer will buzz once, and the motor runs at mid speed.
4. Push the High button, the buzzer will buzz once, and the motor runs at high speed.
5. Push the light button and the two lights will come on. Push it again and the light will turn off.
(7) MAINTENANCE
7.1 The cleaning of the carbon grease filter mesh
The filter mesh is made of high-density stainless steel. Please do not use the corrosive detergent on it.
Keeping this filter clean will keep the appliance running correctly. Please strictly follow the guidelines below.
Method 1: Put the mesh into 40-50 c clean water, pour on detergent, and soak for 2-3 mins. Wear gloves and
clean with a soft brush. Please do not apply too much pressure, as the mesh is delicate and will damage easy.
Method 2: If instructed to do so, it can be put into a dishwasher, set the temperature at around 60 degrees.
pi c6C pi c6C pi c6C
14