eTIGER S4 Combo Secual Mode D'emploi page 15

Advanced settings
For the installation of your accessories, please check the full
manual of www.etiger.com.
Connect more sensors
1. Type your Admin Code +
Go to Accessories > Wireless Sensors and press
2.
3. Select the type of zone and press
4. Within the next 15 seconds, trigger the sensor.
5. You hear one beep: the accessory is registered.
Change the Access Codes
The User Code enables you to disarm your system from the
panel.
1. Type your Admin Code +
Go to System Settings > Access Code > User Code >
2.
3. Change the code and press
digits).
The Admin Code can be changed using the same procedure
(under System Settings > Access Code > Admin Code).
on the control panel.
.
on the control panel.
(the code must consist of 4
EN
.
.
15