Clearing Blockages; Changing The Brush Strip - Hillyard TRIDENT HIL 56082 Mode D'emploi

33
26
HIL 56082 / HIL 56083 - Operators Manual - Trident V14D / V18D

Clearing Blockages

If the bag-full warning light shows before the dust bag
is full, check for blockages. Release the hose by
squeezing the tabs of the retaining ring (11). Reverse
the hose and put the wand-end into the connecting
tube (12). Remove the obstruction by switching on the
machine, holding the hose upright. If necessary
rapidly lift your hand on and off the end of the hose.
12
12
NOTE: Never use a stick or sharp object to clear the
11 11
hose.
Check for blockage in the swivel neck of the power
head and under the orange trap door (33) located on
the bottom of the power head.
Check the passage between the two openings in the
power head for blockage also.

Changing The Brush Strip

32
To replace brush strip, push button (32), remove the
side plate (26) and rotate the brush so that the brush
strip (27) can be pulled out of the opening. Ensure
that the new brush strip is fully inserted, then press
the side plate back into place.
NOTE: Ensure plate is locked in place.
27
Maintenance
11