Optional Components - Carrier 50CO W 40 Instructions D'installation, De Fonctionnement Et D'entretien

11 - TECHNICAL SPECIFICATIONS
Filter fouling is measured by a pressure sensor located in the electrics box.
It is set to 1.5 times the value for the filter when clean (pressure ports upstream and downstream of the filter).
11.1.5 - Standard control elements:
(Factory cables)
- An intake temperature sensor.
- A differential pressure sensor: attached to the electrics box, this allows the difference in pressure upstream and downstream of
the filter to be measured, so as to determine whether the filter is fouled.
- A water leak sensor: this is found at the end of a wound cable located at the bottom of the unit so that it is long enough to extend
downwards into a raised floor, if required, and to be positioned in the area to be monitored. It can be added on request.
It can be added on request.

11.2 - Optional Components

11.2.1 - Heating coil
Moderately tighten the "coil supply" connections to avoid damaging the manifolds.
The coil is adjusted by a two-way or four-way valve equipped with a 0-10V servomotor (mounted and connected).
Coil specifications:
Coil (1 row)
Air flow (m3/h)
Heating capacity (kW)*
Heating capacity (kW)**
* Conditions: return air 17 °C - 50 %, water temperature 80/60 °C
** Conditions: return air 17 °C - 50 %, water temperature 45/40 °C
Heating coil pressure drop*:
Nominal water flow (m³/h)
KV valve
∆P Valve only (mWC)
∆P (Pa) Valve + Coil (mWC)
Nominal flow rate: water ∆T: 20 °C
KV
∆P max.¹ Four-way valve
∆P max.² Two-way valve
W40
Number of coils 1
Capacity (l) 3,82
W40
Nominal Maximum Nominal Maximum Nominal Maximum Nominal Maximum Nominal Maximum
10 000 13 300 13 300
36 40 44
18 21 23
W40
0,9
4
0,6
1,5
W40
4
240
400
HOT WATER
W53
1
4,92
HEATING COIL
W53 W78
13 300 18 800 20 500
44 63 66
23 33 34
HOT WATER
W53
1,1
4
0,8
1,8
W53
4
240
400
W78 W100
1
6,29 6,29
W100 W115
24 500 27 000 27 000
71 73 -
37 38 -
W78 W100
1,68 1,9
4
1,8 2,3
3 3,8
W78 W100
4 4
240 240
400 400
1
27 500
-
-
4
51