Proper Installation And Location; Prior To First Time Use; Loading The Dispenser - Sylvania SE80090 Guide D'utilisation

PROPER INSTALLATION AND LOCATION

LOCATION
•
The water dispenser should be installed in an
environment where the temperature ranges
between 10ºC and 38ºC. Relative humidity
should not be higher than 90%
• Avoid direct sunshine
TIPS
•
If the dispenser is not going to be used for an
extended period of time, turn the switches at the
back to the OFF position, unplug the power cord
and drain the remaining water

PRIOR TO FIRST TIME USE

IMPORTANT: Prior to using the Water Dispenser for the first time, the water tanks need to be flushed in
order to prevent the water from tasting awkward.
The water dispenser tanks also need to be cleaned periodically to prevent buildup of mineral deposits that can affect
water taste and flow. To clean the water tanks:
1. Make sure that the power switches are in the OFF
position
2. Mix one quart of water with either one quart of
vinegar or four ounces of citric acid crystals
3. Pour the solution in the opening at the top of the
dispenser
4. Press each dispenser button until water just
begins to flow from the tap
IMPORTANT: Before use, dispense one quart of water from each tap to make sure the cleaning solution is completely
removed.

LOADING THE DISPENSER

IMPORTANT: Make sure the dispenser is unplugged
with both the hot (red) and cold (green) power
switches set to the OFF position. Before loading, wipe
the top of the bottle with a clean cloth and wash
hands. Avoid touching the part of the bottle that will
be directly in contact with the water dispenser.
1. Invert the bottle on top of the cooler and place
securely on the bottle support collar
•
The rear of the water dispenser should be at
least 10 inches / 25 centimeters from the wall to
allow for proper air circulation
•
Never place the water dispenser on paper or
foam, possibly causing an unstable condition
•
Do not place anything flammable besides the
water dispenser
•
In case the hot or cold water is not needed for an
extended period of time, turn the appropriate
power switch at the back of the dispenser to the
OFF position in order to save electricity
WARNING:
The dispenser should not be turned on
until at least 3 minutes have gone by since it was turned
off.
5. After about twenty minutes, press the dispenser
buttons until no more water comes out of the taps
and drain the hot water tank (see Draining the
Dispenser, page 7).
6. Reinstall the water bottle ( see Loading the
Dispenser, page 5)
2. Press the hot and cold dispenser buttons until
water runs from both taps
3. Plug in the dispenser
4. Set the HOT (red) and COLD (green) power
switches to the ON positions
5. Allow 30 minutes for water to reach hot and cold
temperatures
Contact a local water bottle distributor to purchase
water bottles.
5