Monitor Position Adjustment; Remote Control Unit Preparation - Panasonic CY-VH9300U Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E

Monitor Position Adjustment

N
G
L
I
S
Open the Display Unit
H
7
[PUSH OPEN]
Maximum
120x
1
Push the display release button [PUSH OPEN]
until the display is unlocked.
(Press the button with one hand while holding
the display with the other.)
2
Open the display unit by both hands until a
comfortable viewing angle is reached.
Close the Display Unit
Move the display unit by both hands until the
display release button is locked.
Note:
≥ Always use both hands to open or close the
display unit.
≥ Always check that the display release button is
locked after closing the display unit.
≥ If the display unit cannot be locked, be sure to
consult your dealer and remedy the situation.
50
CY-VH9300U
Display Unit Lateral Angle
Adjustment
30x
30x
You can swivel it to the left and right, 30˚ each way.
Hold the display unit by the non-slip part in the
upper half of it and adjust its lateral angle.

Remote Control Unit Preparation

Battery Installation
Lithium battery
Back side
(supplied)
2
Position B
3
Battery holder
1
Position A
1
Remove the battery holder.
Pull the holder out at position B while pushing
position A as indicated.
2
Install the battery on the battery holder.
3
Insert the battery holder back into its original
position.
Battery Notes
≥ Battery type: Panasonic lithium battery
(CR2025/1F) (supplied)
≥ Battery life: Approximately 6 months under
normal use (at room temperature)
Caution:
≥ Improper use of the battery may cause
overheating, an explosion or ignition, resulting
in injury or a fi re. Battery leakage may damage
the product.
≥ Do not expose the remote control unit to direct
sunlight.
≥ Do not recharge, disassemble, deform or heat
the battery.
≥ Do not put the battery in fi re or water.
≥ Immediately replace used up battery.
≥ Obey local ordinances when disposing of the
battery.
Note:
≥ To ensure that the remote control unit is not
lost or misplaced, use the accessory Magic tape
("Velcro") to secure it at a safe place.
Magic tape ("Velcro")
(supplied)
≥ Remove all oil, water, surfaces where the magic
tapes are to be attached.
CY-VH9300U
E
N
G
L
I
S
H
8
51

Publicité

Chapitres

Table des Matières
loading

Table des Matières