Human Touch HT-7450 Mode D'emploi Et D'entretien page 4

get ready
Unpack the box
Chair
Your massage chair is a precision instrument that can be damaged if dropped. Use at least
two people to move it. No tools are required to complete these instructions.
1. Remove the screw knobs
Before picking up the backrest, unscrew the two
screw knobs from the bottom of the backrest.
2. Install the backrest
Align the guides on the lower sides of the backrest with the track on
the chair base, then slide the backrest firmly onto the chair base.
CAUTION: Be sure all cords and fingers are out of the way
before installing the backrest, to avoid damage or injury.
humantouch.com
Backrest Head Pillow
6
Your Human Touch massage chair comes with a detached
backrest—protecting the environment by using less
packaging and making it easier to maneuver the chair
through tight doorways and corners. Assembling your chair is
easy, just attach the backrest, connect the cables, place the
head pillow and you're done!
3. Replace the screw knobs
From the bottom of the backrest, install and hand tighten
the two screw knobs. Verify that the two screw knobs are
installed and tightened before using the chair.
4. Connect the cables
Connect all cables on the left-hand side of the backrest to
the corresponding connectors on the left-hand side of the
chair base.
Place the head pillow flap over the top
of the headrest.The weighted pillow flap
keeps the head pillow in place.
7
Fully assembled
HT-7450