RISCO Group VUpoint RVCM11W Guide D'installation page 12

Connecting to a Wireless Network using the RISCO Cloud
Connecting the IP camera to a wireless network using the RISCO Cloud (RISCO
Application Server) requires that you first connect the IP camera to the router via
the LAN and then, from the RISCO Cloud Installer Application, define the IP
camera settings and establish a wireless connection. Once a wireless connection
has been established the IP camera can then be disconnected from the router and
installed/mounted.
1. Connect the incoming network cable to the Network port on the IP camera.
2. The GREEN network indicator lights to indicate that your IP camera is now
connected to the network. Continue as explained in Defining IP Camera
Settings.
NOTE – Before disconnecting you must configure the wireless network through
the RISCO Cloud.
3. Once a wireless connection has been established, you may disconnect the IP
Camera from the router and install/mount it anywhere within the monitored
area.
10