Orbegozo FH 5030 Manuel D'instructions page 16

FH 5030 FH 5031 FH 5032 FH 5033 FH 5035
Thermostat knob (D):
With the thermostat knob you can set a constant room temperature.
When the selector switch is set to position
as soon
as the room temperature falls below the set temperature. As soon as the set temperature is reached,
they will switch off. Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise
for a lower temperature setting. You may adjust the thermostat during use. To find the ideal
thermostat setting:
First set the knob to maximum position (rotate clockwise until the knob stops.)
-
As soon as the temperature is comfortable, turn the knob anti-clockwise slowly until the heater
-
goes off.
When using the cool air
Control lamp (E):
The control lamp (E) indicates the operation if st
thermostat switch.
The control lamp shines so long, since the thermostat switches off the device with reaching of the

opposed ambient temperature and begins again if the thermostat again turns on the device.
If the steps switch turned on position

lamp goes out.
Switch off the heater:
To switch off the heater turn the selector switch to the position ( ) and turn the thermostat-knob to
its lowest position. Remove the mains plug from the wall-socket.
Always unplug the heater from the wall-socket when not in use.
Overheating safety device
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot. If this should happen:
First ensure that it was not the thermostat which has switched off the heater. Set the thermostat to
maximum position. If the heater does not switch on, the safety device has been activated.
Remove the mains plug from the wall socket.
-
Let the heater cool down for 30 minutes.
-
Check if the heater had been placed correctly.
-
Check if anything is obstructing the air flow.
-
If necessary, clean the grilles with a vacuum cleaner.
-
Replace the plug into the wall socket and switch the heater on again.
-
If the safety device again switches off the heater:
Remove the mains plug from the wall socket.
-
Have the heater inspected by a Service Centre or by your dealer.
-
or position
setting, the thermostat knob should be in its highest position.
ep (
or the device by the electricity mains is taken, the control
the heater will automatically switch on
) is turned on in combination with the
16