Orbegozo FH 5030 Manuel D'instructions page 15

FH 5030 FH 5031 FH 5032 FH 5033 FH 5035
these instructions must be surrendered to the new
owner!
Safe positioning
The heater must not be located immediately below a socket outlet.

Only use the fan heater when it is standing in a horizontal position. Do not place the heater on

instable surfaces, such as bed, carpets etc. and do not use the heater on uneven position, where
the heater can tip over – otherwise there is a risk of fire.
The heater should be placed with a minimum distance from flammable objects, walls, structure etc.

A safe area to be left free is 100 cm at the front and at the sides and 100 cm at the top. The
appliance opening must not be obstructed in any way.
For your own safety and that of others: water and electricity are a dangerous combination! Do not

use this heater in a bathroom or near a swimming pool. Ensure that the appliance cannot fall into
water (bath wash basin, shower cubicle, etc.)
Please read also the safety information before using.

Do not use the heater on extremely deep-pile carpets!

General description
A air inlet grille
B air outlet grille
C selector switch
D Thermostat knob
E Control lamp
Using your heater
Put the selector switch to position (
The selector switch (C) and the thermostat knob (D) enable you to select the following functions:
Selector switch(C):
) OFF. Plug the power socket in the wall-socket.
= ‚OFF‛. Both the fan and the two heating elements are switched off.
= ‚Cool air‛. Only the fan is switched on.
= ‚Warm air‛ (1250 W) for gradual heating-up.
= ‚Hot air‛ (2500 W) for quick heating-up.
15