Onkyo CBX-300 Manuel D'instructions page 52

Troubleshooting—Continued
Clock
The clock displays --:--
• A power outage has occurred and the time setting lost. Set the clock again (see pages 19 and 40). The timers will all
be set to Timer Off, so you'll need to turn on any necessary timers (see page 45). The timer settings will be preserved.
The time is not displayed in Standby mode.
• Set the CBX-300 so that the time is displayed in Standby mode (see page 40).
AccuClock appears on the display frequently or the clock is not set properly (European models only).
• Make sure the AccuClock function is correctly configured for use with a specific station (see page 41).
• The signal from the station that the AccuClock function is configured to use is weak. Try another station (see page 41).
• The station that the AccuClock function is configured to use is not broadcasting CT (Clock Time) information or does
not support RDS. Try another station (see page 41).
• The AccuClock function cannot set the clock. Set the clock manually (see page 40).
• Once a power outage has been fixed, the AccuClock function will run automatically.
AccuClock no longer works after moving the CBX-300 or antenna (European models only).
• In step 4 of the "AccuClock with a Specific Station" procedure on page 41, try pressing the [CLEAR] button to change
the display to "FM---.--MHz," and then press the [YES/MODE] button.
• Unplug the power cord from the wall outlet, wait 5 seconds or more, then plug it in again.
You want to turn off the AccuClock function (European models only).
• Set the clock manually (see page 40).
Others
"RESET" appears on the display when the power cord is plugged in.
• The power cord has been disconnected for a long time, or a prolonged power outage occurred. All settings have
reverted to their factory defaults, so you'll need to make any necessary settings again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's
malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CBX-300 contains a microcomputer. In very rare situations, severe interference, noise from an external source,
or static electricity may cause it to malfunction or lockup. In the unlikely event that this should happen, unplug the
power cord, wait at least 10 seconds, and then plug it back in again. If this doesn't resolve the issue, reset the CBX-300
to its factory defaults (see page 49).
52
En-