Installing The Ipod Dock Adapters - Onkyo CBX-300 Manuel D'instructions

Installing the iPod Dock Adapters

About the iPod Dock Adapters
The supplied iPod dock adapters can be used with a wide
range of iPod models (4th Generation and photo) and
iPod mini, however, if the Apple iPod Universal Dock
Adapter that fits your iPod is available, it is recom-
mended that you use it instead.
If you have a 5th Generation or later iPod or an iPod
nano, be sure to use the dock adapter that came with it.
The CBX-300 comes with two dock adapters. Each
adapter has a letter on the rear, A or B, as shown below,
so you can determine which iPod models it supports.
A A
B
B
The following table shows which iPod models are sup-
ported by each adapter. Be sure to use the correct adapter
for your iPod.
iPod model
MENU
Special Edition)
4th Generation iPod and
U2 Special Edition
MENU
iPod mini
MENU
iPod photo
Notes:
• Inserting your iPod into the CBX-300's dock without
the appropriate adapter installed will damage the dock
connector. Even if the correct adapter is installed,
don't rock your iPod forcibly while it's inserted in the
dock, as this will also damage the dock connector.
• When you insert or remove your iPod, carefully move
it straight into or out of the dock at the same angle as
the dock connector.
A B
20 GB
✔
(including U2
✔
40 GB
✔
✔
30 GB
✔
40 GB
✔
60 GB
Installing the iPod Dock Adapters
1. Removing the dock's protective cover
Keep the protective cover in a safe place so that you
can put it back on if you don't intend to use the dock
for an extended period.
CBX-300's top
Push the tab forward and lift
off the protective cover
2. Installing the dock adapter
Hold the adapter with its slot facing away from you
and push it into the dock until it clicks into place.
Removing the Dock Adapters
To remove the dock adapter, insert a small flathead
screwdriver into the slot, and lift it out, as shown below.
Protective cover
Make sure the slot is at
the rear.
En-
15