Installation And Connection - Bartscher 135.001 Mode D'emploi

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Place the device at a safe distance to children.
•
Make sure there is a minimum distance of 15 cm between the wall and the back and
the sides of the device, in order to provide sufficient air circulation.
•
You must not block the ventilation slots.
•
Wait at least one hour until the refrigerant has settled. Connect the device to a
socket only afterwards.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
All manuals and user guides at all-guides.com
- 25 -