ARENDO 304592 Mode D'emploi page 16

4. Before initial use
• Ensure that the packaging of this appliance has been properly disposed of.
• Keep small parts and plastic bags away from babies and children.
• Clean the appliance with a damp cloth after taking it out of the packaging.
Ensure that water does not get into the appliance and never immerse the
appliance in water to clean it!
• Ensure that the rated voltage of the connected socket matches the voltage
specified on the type plate of the appliance.
• Place the product on a flat and dry surface.
• Ensure that all parts of the appliance are correctly installed before using it.
• Do not switch on the beverage mixer without the jar. Never touch the rotating
parts of the appliance!
• Before using the appliance, extend the cable fully and ensure that it is not
damaged.
• The appliance is designed only for brief periods of operation (1 minute). Do not
use it for more than 1 minute continuously.
• Ensure that you always take a break of 1 minute between each use.
5. Commissioning
Take the appliance out of the packaging and remove all the packaging material.
Check the supplied appliance for completeness. Ensure that the On/Off switch is
in "Off" (0) position before connecting the mains plug to a suitable and properly
installed socket.
Now fill the stainless steel jar with the desired ingredients. Put the On/Off switch
to "I" or "II" to select the desired speed. Insert the cup into the holder so that the
safety switch is pressed. Alternatively, use the safety cap to activate the switch
and mix your drink while holding the cup.
Finally, set the On/Off switch to "0" and allow the appliance to cool down for
about 1 minute. Always keep the beverage mixer dry.
Caution! To avoid overheating, the appliance should not be used for more than 1
minute each time!
16
English