Manual Defrost; Cleaning, Care & Maintenance; Cleaning The Condenser - Bartscher HTR100 Mode D'emploi

UK
Should the parameter need adjusting:
1. Press and hold the
2. Press the or
3. Press the button to store the new value and cycle to the next parameter
NOTE: The controller times out after 10 seconds if no buttons are pressed

Manual Defrost:

Press and hold the
Cleaning, Care & Maintenance
1. Switch off and disconnect from the power supply before cleaning
2. The doors can be removed for ease of cleaning
3. Clean the interior of the appliance as often as possible
4. Do not use abrasive cleaning agents. These can leave harmful residues
5. Clean the door seal with water only
6. Always wipe dry after cleaning
7. Do not allow water used in cleaning to run through the drain hole into the evaporation pan
Replacing the Interior Lamp
Call your dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare part.

Cleaning the Condenser

Periodic cleaning of the Condenser can extend the life of the appliance, recommend that a agent
or qualified technician clean the condenser.
Trouble Shooting
If your appliance develops a fault, please check the following table before making a call to the
helpline
Fault
The appliance is not working
4
button for six seconds. The "E1" parameter is displayed
buttons until the required value is displayed
button for 6 seconds to begin automatic defrost. The defrost light illuminates
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Action Required
Check the unit is plugged in correctly
and switched on
Call or qualified technician
Replace the fuse
Check power supply
Call or qualified technician