Continuous Recording - Teac W-865R Manuel Du Propriétaire

3 5
2 1
This function allows you to make uninterrupted recordings on
both sides of two tapes.
1
Load cassette tapes for recording into the TAPE I and
TAPE II compartments.
2 Set the REV MODE switch to the "p" (CONT PLAY)
position.
< Set the DOLBY NR switch to the ON position if you want to.
3
Press the TAPE I deck's RECORD button.
The deck enters the record-pause mode. "J" and "
will light on the display. Now adjust the recording level and
any other settings, as required.

Continuous Recording

4
A A 1
Side "A" facing you
REC
4 Check the recording direction.
If an indicator is lit which points in the direction opposite to
the one desired, change the direction by pressing the
opposite direction play button (h or y).
Be careful not to press play button whose arrow points in
the same direction as the indicator. Doing so will start
recording.
Recording is done in this order:
TAPE I
TAPE II
You can start recording from side "B" of TAPE I. But if you do
so, side "A" of this tape is not recorded: when recording
reaches the end of side "B", the TAPE II deck starts recording.
< The TAPE II deck always starts recording from side "A".
5 Start recording.
Recording starts when you press the PAUSE button or the
play button whose arrow points in the same direction as the
indicator on the TAPE I deck.
When recording is finished on the TAPE I deck, the TAPE II
deck automatically starts recording.
"
< The transition from TAPE I to TAPE II takes several seconds.
A To stop recording
Press the stop button (H) of the deck which is currently
recording.
Side "A"
x
Side "B"
x
Side "A"
x
Side "B"
19