Teac W-865R Manuel Du Propriétaire page 9

In this manual we only refer to the buttons on the cassette deck
itself. However, their remote counterparts can be used in the
same way.
A Power switch
This switch toggles the unit on/off.
The equipment draws nominal non-operating power from
the AC outlet with its POWER switch in the OFF position.
B Reverse mode switch (REV MODE)
This switch is used to switch between reverse modes.
C TIMER switch
This switch is provided for use with a commercially available
audio timer, to allow timer controlled recording or playback.
Normally, leave this switch to the OFF position.
D
DOLBY NR switch
This switch toggles the Dolby Noise Reduction system on/off.
In playback you need to set this switch to the same position
as when the recording was made.
E TAPE I compartment
F
Remote sensor
This receives remote commands. When using the remote
control unit, point it at this sensor.
G Counter clear buttons (CLEAR I and CLEAR II)
Pressing these buttons reset the tape counter readings for
TAPE I and TAPE II, respectively.
H INTRO CHECK button
Pressing this button allows you to identify recorded segments
by listening to the first 15 seconds of each segment.
I Synchro reverse button (SYNC REV)
Pressing this button activates the synchro reverse dubbing
function.
J
BLANK SCAN button
This button toggles Blank Scan on/off.
K
Display
This shows tape counters, level meters, etc.
L
Parallel record button (PARALLEL REC)
This button lets you simultaneously record on both decks.
M
Dubbing start button (DUB START)
This button is used when copying the contents of a tape from
TAPE I to TAPE II, either at normal or high speed.
On the remote control unit a pair of buttons is provided for
each speed. You need to press both buttons at the same
time.
N TAPE II compartment
O EJECT buttons
Pressing these buttons opens the TAPE I and TAPE II
compartments.
P Tape transport control buttons
RECORD
Pressing this button shifts the corresponding deck to record-
pause mode.
When you use the remote control unit, you need to press a
pair of buttons at the same time to shift either deck to record-
pause mode.
PAUSE
Pressing this button temporarily stops playback or recording.
Recording mute (REC MUTE)
This button is for creating the 4-second blank space needed
for proper operation of the Computomatic Program Search
(CPS) function.
m/,
Fast-forward/Rewind
H
Stop of playback/record
h / y
Reverse side play/Forward side play
Q Headphones jack (PHONES)
Plug your headphones into this jack.
R PITCH CONTROL
This control is used to vary the playback speed.
S REC LEVEL control
This control is used to adjust the recording level.
T MIC jack and level control
Insert your microphone into this jack and use the knob to
adjust the level of mic input.
< The MIC jack is mono. You cannot use a stereo microphone
with this cassette deck.
9