Antari W-101 Mode D'emploi page 7

produces bubbles. For wireless operation with the W-1, set the power switch to
"Wireless Mode". Now please refer to chapter "W-1 Wireless Remote" for
setting the remote control.
W-1 Wireless Remote
The wireless remote control system W-1 consists of a transmitter equipped
with two buttons for bubbles on and off, and a receiver pre-attached to the
rear panel of each W-series model.
* Transmitter:
With the transmitter it is possible to emit bubbles via radio over a distance
of up to 50 meters. The transmitter is compatible to any receiver of the W-
series and can control an unlimited number of machines in parallel.
Press the button "A", to emit bubbles. As control, the blue LED lights. To
stop the bubble output, press the button "B".
* Receiver:
The receiver is tested and pre-attached to the rear panel of each W-series
model. Please do not try to remove it. The receiver responds to up to 5
different transmitters that are registered with the machine. The included
transmitter has been registered with the machine before shipment. It can
be directly operated without any start-up setting.
-5-