Antari W-101 Mode D'emploi page 8

- Registering transmitters:
To operate the machine with a different transmitter than the included one,
or to operate it with up to 5 different transmitters, each transmitter must
be registered first. There is an LED light on the rear control panel of the
machine. When the machine is turned on, the green LED will be flashing for
15 seconds. During the 15-second interval, users can register signals for
one or more transmitters. For this purpose, press the button "A" on each
transmitter. If the registering signals of the transmitters are well received
by the receiver, the green LED will stop flashing and light permanently. The
previous transmitters are cleared from the memory of the receiver. If no
transmitter is registered while the machine is switched on, the memory of
the receiver will keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the
machine. While the green LED is flashing, press the button "A" on each
transmitter to establish the signal transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the
machines at the same time. While the green LEDs are flashing, press the
button "A" on the transmitter to establish the signal transmission.
- Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably
exhausted and must be replaced. For this purpose, take off the housing
cover and remove the used battery. Insert a fresh 12 V battery, type 23A as
indicated in the battery compartment and refit the housing cover.
Technical Specifications
Power
Fuse
Wei ght
Dimensions (LxWxH)
Functi ons
Tank capacity
Remote incl uded
Carrier frequency
Battery
Range
120 V AC, 60 Hz (120 V model)
230 V AC, 50 Hz (230 V model)
F 2 A/250 V (120 V model)
T 1 A/250 V (230 V model)
net 3.4 kg; gross 4.2 kg
241 x 170 x 172 (mm)
O n/ off, n o DMX interface
1 liter
W- 1
UHF-433.920 Mhz
12 V, type 23A
approx. 50 m
-6-