Teeter Better Back Instructions D'assemblage Et D'utilisation page 6

FIGURE 1
FIGURE 2
FIGURE 3
4
Attach Vibration Cushion to Table Bed
STEP 1
• Pull apart the Velcro on all of the straps on the Vibration Cushion.
• Lay the Vibration Cushion on top of the inversion table bed with the
Head Support located at the top end of the table bed. Ensure the
electrical cords are located on the left as you stand facing the unit and
that they are free from the underside of the Vibration Cushion.
CAUTION: Keep your face and eyes clear of the elastic straps
!
when stretching them for installation.
• Wrap the top horizontal straps around the table bed and secure
together using the Velcro strips (Figure 1).
• Pull the top vertical strap over the top of the table bed and wrap around
secured horizontal straps (Figure 2) to secure onto itself with the Velcro
strips.
• Wrap the lower horizontal straps around the table bed and under the
Main Shaft Housing. Secure together using the Velcro Strips (Figure 3).
• Pull the lower vertical strap under the bottom of the table bed and
wrap around the secured horizontal straps to secure onto itself with the
Velcro strips (Figure 3).
.