Setting Up Your Camera; Install The Battery; Charge The Battery; Turn On The Camera - HP Photosmart R725 Mode D'emploi

2
Setting up your
camera

Install the battery

1. Open the Battery/Memory card
door by sliding the door latch as
indicated on the Battery/Memory
card door.
2. Insert the battery in the larger slot,
pushing the battery in until the
latch catches.
3. Close the Battery/Memory card
door.
Note Turn the camera off before
removing the battery. Fully charge the battery before
using it the first time.

Charge the battery

You can charge the battery
in the camera, using the
AC adapter.
Connect the AC power
adapter to the camera,
then plug it into an electrical outlet.
The camera's blinking Battery Charging light indicates
that the battery is charging; the battery is fully charged
when the light stays on solid (approximately 2–3 hours).

Turn on the camera

To turn on the camera, press the

Setting up your camera

button.
9