U.S.Robotics ISDN PCI Card TA Guide D'installation page 2

Installation and Configuration in Windows 95
1. Once you have installed the ISDN PCI Card TA in its slot in the system
unit, the hardware recognition feature of Windows 95 will recognize a new
hardware component and automatically start the Hardware Wizard.
Click Next.
2. Click Other Locations to enter the source folder for the device driver
software.
3. Enter the source directory where the driver software is located. For example, if
your CD-ROM drive uses the drive letter D, enter D:\WIN95. Ensure that the
installation CD-ROM for your ISDN PCI Card TA is inserted in the CD-ROM drive.
Then click OK.
4. Confirm the location of the driver by clicking Finish. Insert the installation CD-
ROM and click OK. Enter the path to the device driver files one more time and
click OK. The Hardware Wizard updates the driver database, copying the ISDN
PCI Card TA driver to your hard disk. This process takes a bit of time; watch
the progress indicator on your screen. During the copying process, you may see
an error message. Simply confirm this message by clicking OK.
5. When the software installation is completed, the ISDN PCI Card TA configuration
wizard will start. Select the D channel protocol required for your ISDN access.
Your ISDN service provider uses a specific D channel protocol for your ISDN
access. For European ISDN access, this will almost always be DSS1. If your
ISDN provider or the PABX you are connected to use a different D channel
protocol, select this protocol here. If you do not know which D channel protocol
you are using, contact your telephone company or ISDN provider.
6. The two following dialog boxes configure the MSNs for the two available B
channels. Your telephone company will inform you which MSNs (multiple
subscriber numbers) can be used to call you on ISDN. Only the Dial-Up and the
Loopback Test will use the MSNs entered in this dialog box. You can use the
same or different MSNs for the various applications, which are configured there.
7. This will conclude the installation and configuration of the ISDN driver software.
Click Finish to continue.
8. The last installation step requires that you insert the Windows 95 installations
CD-ROM. Wait for your CD-ROM drive to recognize the new CD-ROM. Enter or
select the correct source path, and click OK. This will install the Windows 95
components for the WAN Miniport device driver, concluding the installation
process. During the copying process, you may see an error message. Should
this occur, simply travel through the message by clicking OK. This will conclude
the installation process.
9. You must restart your PC for the new installation to take effect. Click Yes to
confirm. After the system restarts, your ISDN PCI Card TA will be ready to use.