Identification; Product Description And Type Designation; Product Markings; Declaration Of Conformity To Product Standards - Videotec GEKO IRH Manuel D'instructions

4 Identification

4.1 Product description and type
designation
State of the art illuminator, which provides
high reliability and excellent image quality. The
GEKO lights the entire scene evenly, eliminating
hotspots and underexposures, for unbeatable
night-time images and secure surveillance of the
area. The high efficiency heat sink body ensures
maximum LED durability and protection against
over-temperatures, whereas the front glass, made
of special technopolymer, provides high infrared
transmittance. The GEKO illuminators are protected
against electrostatic discharges.
These illuminators incorporate a circuit that allows
them to be powered directly from a 12-24Vdc or
24Vac supply.
A weatherproof box with 230Vac or 120Vac power
supply is available as accessory for one or two GEKO
illuminators.
GEKO is supplied with a wall-mount bracket that
rotates horizontally and vertically and can be
assembled in a housing by means of the OSUPPIR
bracket.

4.2 Product markings

See the label attached to the outside of the package.
5 Declaration of conformity
to product standards
• Electrical safety: EN60598
• Safety of laser products: EN60825-1
• Electromagnetic compatibility: EN55022, Class B
• Immunity: EN50130-4
• FCC Part 15, Class B
4
6 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

6.1 Unpacking and contents

6.1.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
6.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Illuminator with bracket
• Wall-fastening bracket
• Instructions manual
6.2 Preparatory work before
installation
Fasten the top bracket (01) to the lamp using the
screws and washers (02) supplied.
01
02
Fig. 1
02