How To Use Energy Saving Mode - Tiger PDU-A Manuel D'instructions

5

How to use Energy Saving Mode

Energy Saving Mode applies to Boiling and Keep Warm
cycles.
• Energy Saving Mode Boiling: heater will shut off when
temperature reaches 208°F and reduce boiling steam.
(Depending on the room and water temperature, the
steam cut function may not work.)
• Energy Saving Mode cycle applies after 2 hours not in
use. It reduces approximately 9°F from regular setting
temperature e.g.: If you select 208, Energy Saving Mode
is 203.
1
Select [Energy Saving Mode]
Press and hold Energy Saving
Beeping
sound
Light
illuminates
■Disabling steam cut function for
Energy Saving Mode cycle.
Boiling cycle with dechlorinate.(See p. 10)
2
Select [Keep Warm]
(See p. 11)
3
Once water reaches boil-
ing point, it automatically
switches to Keep Warm
mode.
■When boiling cycle is done...
Light
illuminates
Light
turns o
13 13
key for a second.
Display
Flashing
Beeping sound
(repeats 5 times)
Light
illuminates
■Water reaches setting temperature...
Beeping
sound
■If the unit is not in use for 2 hours, it
will automatically switch to Energy
Saving Mode.
( 9°F lower than regular setting temperature)
How to bring back to setting
temperature.
Temp.Set Unlock
Press or
setting temperature about a minute.
How to cancel Energy Saving
Mode
Energy Saving
Press key for a second. (It
automatically reheats when the temperature is low.)
You may hear a buzzing
sound when you are selecting
Energy Saving Mode, the unit
automatically reheats to setting
temperature.(See p. 18)
Keep your face or other body parts away
Caution
from the steam vent which may be hot
during Energy Saving Mode boiling cycle.
Display
key once. Bring back to