emerio FN-108740.4 Mode D'emploi page 5

PARTS DESCRIPTION
1. Guard fastening screw
2. Front guard
3. Fan blade
4. Blade fastening screw
5. Rear guard fastening screw
6. Rear guard
7. Nut
8. Motor
9. Supporting tube
10. Rubber ring
11. Fastening knob
12. Tripod leg
13. Butterfly fastening screw
14. Connecting rod
ASSEMBLING INSTRUCTIONS
** Please assemble correctly by the following orders when using.
1. Tripod leg assembly
Take down the butterfly fastening screws (13) from the legs.

Attach the three connecting rods (14) together with each tripod leg (12). Fix them firmly by using the

butterfly fastening screws through the holes in the connecting rods.
Check the screws; make sure the legs stand securely.

2. Fan head assembly
1) Rear guard:
Unscrew the rear guard fastening screw (5) on the front of the motor (8).

Insert the two hangers (the ones without hole) on the rear guard into the two oval bushings (the bigger oval

holes) on the front of the motor.
Align the third hanger on the rear guard with the screw hole on the front of the motor and fix it by fastening

the screw (5). Make sure the handle on the rear guard is on top of the fan basket.
2) Fan blade:
Loosen the blade fastening screw (4) on the back of the fan blade (3).

Slide the fan blade (3) onto the motor shaft.

Align the blade fastening screw (4) with the locking notch on the motor shaft. Tighten the screw to secure

the fan blade firmly.
3) Front guard:
Put the hook of the front guard (2) onto the top of the rear guard (6).

Close the retaining clips. Ensure the screw hole on the front guard and rear guard are lining up.

Use the guard fastening screw (1) to secure the front guard and rear guard. Tighten with the nut (7).

3. The whole assembly
Loosen the fastening knob (11) on the top of the assembled tripod.

Check and make sure the rubber ring (10) is on the supporting tube (9) of the fan head. Insert the

supporting tube into the hole on the top of the assembled tripod.
- 4 - FN-108740.4