Bosch GLM 40 Professional Notice Originale page 29

OBJ_BUCH-2264-003.book Page 29 Friday, December 18, 2015 2:54 PM
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 27.
Press button 6 [+]. The calculated area is shown on the display, and
symbol "+" flashes.
Press the measuring button 2 [
ment. Measure the area as described in section "Area Measure-
ment", see page 27.
Press button 6 [+] to calculate the sum. The end result is shown at
the bottom of the display.
To exit addition, press button 4 [Func].
Subtracting Values
To subtract values, press button 3 [–]. The subsequent steps are the same as for
"Adding Values".
Changing the Unit of Measure
Unit of measure "m" (metres) is set by default.
Switch the measuring tool on.
Press and hold button 4 [Func] until " " and "mft" flash on the display. "0.000 m" is
shown at the bottom of the display.
Press button 6 [+] or button 3 [–] to change the unit of measure.
"0.000 ft" is shown at the bottom of the display.
Bosch Power Tools
English | 29
] to start another area measure-
1 609 92A 23E | (18.12.15)