Inserting/Replacing The Batteries; Initial Operation - Bosch GLM 40 Professional Notice Originale

OBJ_BUCH-2264-003.book Page 24 Friday, December 18, 2015 2:54 PM
24 | English
Length measurement
Continuous measurement
Area/surface measurement
Volume measurement
Simple Pythagoras Measurement
g Memory value display
h Error message "Error"
Assembly

Inserting/Replacing the Batteries

Using alkali-manganese or rechargeable batteries is recommended for operation of
the measuring tool.
With 1.2-V-rechargeable batteries fewer measurements could be possible than with
1.5-V-batteries.
To open the battery lid 7, press the latch 8 and remove the battery lid. Insert the bat-
teries/rechargeable batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery compartment.
When the battery symbol appears
dividual measurements are still possible.
When the battery symbol
placed. Measurements are no longer possible.
Always replace all batteries/rechargeable batteries at the same time. Do not use dif-
ferent brands or types of batteries/rechargeable batteries together.
 Remove the batteries/rechargeable batteries from the measuring tool when
not using it for longer periods. When storing for longer periods, the batteries/re-
chargeable batteries can corrode and self-discharge.
Operation

Initial Operation

 Do not leave the switched-on measuring tool unattended and switch the mea-
suring tool off after use. Other persons could be blinded by the laser beam.
1 609 92A 23E | (18.12.15)
for the first time on the display, at least 100 in-
flashes, the batteries/rechargeable batteries must be re-
Bosch Power Tools