Recommendations; Maintenance - JANE IMATRIX Mode D'emploi

L. RECOMMENDATIONS
Keep this instruction book for future reference. Always keep it in the
pocket inside the seat.
Ensure that inside the car, both luggage and any other object liable
to cause injury in the event of an accident are properly fastened or
stored.
The iMATRIX safety seat should be securely fastened to your vehicle,
using the iPLATFORM base, even when it is not in use, because in the
event of an accident it could cause injury to the other occupants of
the vehicle.
Remember not to use the I MATRIX safety seat in cars fitted with a front
airbag, unless it is disconnected or disabled, for which you should con-
sult the car manufacturer or retailer.
Click on the link: www.jane.es for more information about installing
your new iMATRIX.
52
EN
M. MAINTENANCE
Do not expose the cover to sunlight for long periods. When the seat is
not in use, cover it or store it in the boot.
Wash the plastic parts with warm water and soap, carefully drying all
the components afterwards.
The upholstery can be removed for washing. Follow the instructions
below:
Unfasten the safety harness clip and pass it through the slot in
the upholstery.
Take off the rubber bands that go underneath the car seat belt
fasteners.
Remove the ones found on the headrest buttons too.
Take the upholstery off the I MATRIX safety seat.
Undo the Velcro strips found in the seat belt area, and those on the
bottom of the headrest then carefully pull the upholstery.
Wash by hand at a temperature never higher than 30° C.
To refit the cover, follow the same steps in reverse order.