Philips SWAROVSKI Active Crystals SWB9000/00 Mode D'emploi page 20

Notice for USA
this device complies with Part 15 of the FCC rules. operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
this equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. these
limits are designed to provide reasonable protection against harmful
interference in a residential installation. this equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. however there is no guarantee that interference
will not occur in a particular installation. if this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
•
reorient or relocate the receiving antenna.
•
increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/ tV technician for help.
Warning
Changes or modifications made to this equipment not expressly
approved by Philips may void the FCC authorization to operate this
equipment.
important 18 en