Installation Requirements; Important Notes To The Installer; Important Notes To The Consumer; Grounding Instructions - Dacor DMR24M977WM Instructions D'installation

Masquer les pouces Voir aussi pour DMR24M977WM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The importance of the proper installation of your new
appliance cannot be overemphasized. Installation should
be done by a qualified installer.
Before you begin the installation process, read this entire
installation instruction manual. It contains information
necessary for proper, safe installation.
Any questions or problems with the installation should
be directed to your Dacor dealer or the Dacor Customer
Service Department at 800.793.0093. You can also visit
our web site at www.Dacor.com.
IMPORTANT NOTES TO THE
INSTALLER
• Read all of the installation instructions before
installing the Microwave In-A-Drawer™.
• Remove all packing material before connecting
the electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the
consumer.
IMPORTANT NOTES TO THE
CONSUMER
Keep these instructions with your use & care manual for
future reference.
• When using any microwave oven generating
heat, there are certain safety precautions you
should follow, that are listed in the use & care
manual. Read the use and care manual and follow
all safety precautions carefully.
• Be sure your Microwave In-A-Drawer™ is installed
and grounded properly by a qualified installer or
service technician.
For SAFETY CONSIDERATIONS do not install the drawer
in any combustible cabinetry, which is not in accord with
the stated clearances and dimensions on pages 3, 4 and
5. See Figure 2 (for 24") or Figures 4 and 5 (for 30").

Installation Requirements

GROUNDING INSTRUCTIONS

Improper use of the grounding plug can result in a
risk of electric shock.
This appliance is equipped with a three-prong grounding
plug for your protection against possible electric
shock hazards. It must be plugged into a grounded
wall receptacle. If only a two-prong wall receptacle
is available, it is the responsibility of the customer to
have it replaced with a properly grounded three-prong
wall receptacle. Do not under any circumstances,
cut or remove the third (ground) prong from the
power cord. Do not use an adapter plug. Do not use
an extension cord. If the power supply cord is too short,
have a qualified electrician or serviceman install an outlet
near the appliance. Do not use a Ground Fault Circuit
Interrupter.
Power supply cord with
three-prong grounding plug
Grounding type wall receptacle
(ground fault circuit not allowed)
E2
WARNING

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dmr24m977wsDmr30m977wmDmr30m977ws

Table des Matières