Machine Stop - Nilfisk SR 1550C B-D Manuel D'utilisation

Waste collection (SR 1550C B)
– Press the push-button to operate the fan.
– Skirt opening: pull the distributor lever.
– Make sure that the skirt closing panel is completely
open.
– To start and lower the main and side brooms, pull the
distributor lever.
– Push the lever to use only the main broom.
When necessary, dump the hopper as follows:
– Lift the main and side brooms.
– Switch off the fan by pressing the push-button
– Close the skirt.
– Drive the machine to the appointed dumping area.
– Lift the hopper to the correct dumping height.
– Open the skirt.
– Lower the hopper.
– Close the skirt.
– Activate the filter shaker for approx. 20 seconds.
– Stop the brooms by moving the central lever back to the
central position.
– Push the lever to lift the main and side brooms.
– Push the lever to close the skirt.
– Press the push-button to stop the fan.
– Pull the lever to lift the hopper to the required dumping
height.
WARNING!
Move the machine extremely slowly when the
hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a
slope.
– Open the skirt by pulling the lever to dump the hopper.
WARNING!
When dumping the hopper, make sure that
nobody is near the machine.
– Push the distributor lever to lower the hopper.
– Push the lever to close the skirt.
– After dumping and with the hopper in the lowered
position, activate the filter shaker for approx. 20 seconds
by pressing the relevant push-button.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
33014094(1)2005-07 A

MACHINE STOP

At the end of the working shift, stop the sweeper in the
appointed area with:
– Brooms in the lifted position;
– Hopper in the lowered position;
– Parking brake lever engaged;
– Lights off (if on);
– Engine off;
– Ignition key removed.
WARNING!
Never leave the hopper in the lifted position
without using the safety props (1, Fig. L).
USER MANUAL
11