Machine Stop - Nilfisk SR 1700 D Manuel D'utilisation

USER MANUAL
When necessary, dump the hopper as follows:
– Lift the main broom.
– Lift the side broom.
– Close the skirt.
– Drive the machine to the appointed dumping area.
– Lift the hopper to the correct dumping height.
– Open the skirt.
– Lower the hopper.
– Close the skirt.
– Activate the filter shaker for approx. 20 seconds.
– Lift the right side (left side optional) broom and the main
broom by pressing the push-button. The brooms stop
rotating.
– By pressing the push-button lift the hopper to the
required dumping height.
WARNING!
Move the machine extremely slowly when the
hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a
slope.
– Skirt opening: open the skirt by pressing the joystick
push-button.
– Make sure that the skirt closing panel is completely
open.
– Press the push-button to lower the hopper, so that it is
supported by the rubber buffers on the frame.
WARNING!
When dumping the hopper, make sure that
nobody is near the machine.
– Skirt closing: press the push-button to close the skirt
closing panel.
– Operate the filter shaker by pressing the push-button.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
10

MACHINE STOP

At the end of the working shift, stop the sweeper in the
appointed area with:
– Brooms in the lifted position;
– Hopper in the lowered position;
– Parking brake lever engaged;
– Lights off (if on);
– Engine off;
– Ignition key removed.
WARNING!
Never leave the hopper in the lifted position
without using the safety props (1, Fig. L).
33014814(1)2005-07 A