Velleman DVM601 Notice D'emploi page 7

the red lead connection.
• Press the Hz/% button to switch to frequency; press again to see the
duty cycle (%).
Range Resolution
400.0mV*
4.000V
AC/DC current measurement
• Connect the red test lead to the µA/mA [6] input jack (max. 400mA) or
10A [7] input jack and the black test lead to the COM jack [5].
• Set the rotary switch [3] in the desired current range (<4mA: µA
<400mA: mA
choose between AC and DC current.
• Open the circuit in which the current is to be measured and connect the
test leads to the circuit IN SERIES.
• Read the current value and the polarity of the red lead connection on the
LCD display.
Range
400.0µA
4000µA
Resistance, diode test and audible continuity test
• Connect the red test lead to the Ω-jack [4] and the black test lead to the
COM jack [5] (the red lead has a positive polarity "+").
• Set the rotary switch [3] in the Ω
voltage at this setting!
• Use the mode button [13] to choose between Ω, diode or continuity test.
• If the resistance being measured is connected to a circuit, turn off the
power and discharge all capacitors before applying the test probes.
• Connect the test leads to the resistor to be measured and read the LCD
display.
Note: wait a few seconds for a stable reading when measuring resistors >
1MΩ.
Range Resolution
400.0Ω 0.1Ω
4.000kΩ
• For diode tests, connect the red test lead to the anode of the diode to be
tested and the black test lead to the cathode of the diode. The approx.
forward voltage drop of the diode will be displayed (typically 0.400 –
0.700V). If the connection is reversed, the display will show "OL".
09/04/2009
Range
0.1mV 40.00V
1.0mV 400.0V
, <10A: 10A
Resolution
0.1µA
1µA
Range
40.00KΩ
1Ω 400.0kΩ
DVM601
Resolution
10mV
100mV
) and use the mode button [3] to
Range
400.0mA
10A
range position. Do not apply input
Resolution
10Ω
100Ω
7
Range Resolution
600V
*: no auto-ranging for AC
Resolution
100µA
10mA
Range Resolution
4.000MΩ
40.00MΩ
®
©2008 Velleman Components nv
1V
,
10kΩ
1MΩ