Rimage PrismPlus! Perfect Image Manuel D'utilisation page 23

d. To close the tray and start the cleaning cycle, press the operator button. When the
cleaning cycle is complete, the tray opens.
e. If necessary, repeat step d.
f. Remove the cleaning pad with attached disc.
g. Using a cotton swab soaked in the cleaning solution, clean the front two ribbon guides.
4. Prepare the PrismPlus for use.
a. Power off the PrismPlus.
b. Reinstall the ribbon.
c. Replace the top cover.
Note: If the printing pad on the tray becomes wet, allow the printing pad to
completely dry before using the PrismPlus.
d. Power on the PrismPlus.
Cleaning the printhead – alternate method
If a cleaning pad is not available, use the following cleaning procedure.
1. Prepare the PrismPlus.
a. Power on the PrismPlus.
b. To open the printer tray, press the operator button.
c. Power down the PrismPlus.
d. Remove the top cover.
e. Remove the ribbon. Refer to Changing the print ribbon on page 18.
2. Clean the printhead.
Important! Do not remove the printhead.
a. Lightly soak a cotton swab in isopropyl alcohol.
b. Insert the cotton swab in the drawer opening and lift the swab upward as you run the
swab against the printhead elements.
3. After the alcohol on the pr
a. Replace the ribbon.
b. Replace the top cover.
c. Power on the PrismPlus.
110635_H
Bottom of printhead shown to
illustrate elements to clean
inthead dries, prepare the PrismPlus for use.
Maintain the PrismPlus
Clean convex surface whil e
printhead is still installed
17