AFX SPIDER Manuel D'utilisation page 5

fixture.
2. Connect the end of the cable coming from the
first fixture which will have a (female) 3 pin
connecter to the input connecter of the next fixture
consisting of a (male) 3 pin connecter. Then,
proceed to connect from the output as stated
above to the input of the following fixture and so
on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initialized
for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also
require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete instructions
for this type of setup and configuration.
FUNCTION MENU
DMX Address
Channel Mode
Show Mode
Slave Mode
Black Out
Sound State
Sound Sense
Pan Inverse
Tilt1Inverse
Tilt2Inverse
Tilt3Inverse
Back Light
Auto Test
Fixture Time
Firmware Version
Defaults
System Reset
Function Mode
DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Press the either the MENU, UP or DOWN buttons until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. Press ENTER to set your desired DMX address.
Channel Mode
The unit has 12 or 43 channels that can receive the International DMX signal.
Show Mode
The user can select between【Sound】and 【Auto】mode
©Copyright LOTRONIC 2015
A001---A512
12 ch, 43ch
Sound, Auto
Master, Slave
YES, NO
ON, OFF
0 –100 off – the most sensitive
YES, NO
YES, NO
YES, NO
YES, NO
On, Off
Automatic test
0----9999
V104
YES,NO
YES,NO
9BEAM-FX Page 5