Startup - AL-KO MH 5065 R Traduction Du Mode D'emploi Original

Safety instructions
The machine is not allowed to be used in
commercial applications
The machine must not be operated if the ope-
rator is under the influence of alcohol, drugs
or medication.
Comply with working time regulations in force
in your country.
Work only when there is adequate daylight or
artificial lighting.
CAUTION!
Always perform a visual check prior to
start-up.
Use the machine only in perfect working or-
der.
Note that the user is responsible for accidents
and damage caused to other persons and/or
their property
Do not disable safety and protective devices.
Do not place your hands and feet close to any
rotating parts.
Never lift or carry the mower while the motor
is running
Always ensure stability when working.
The user is responsible for accidents invol-
ving other people and their property.
Do not leave the appliance unsupervised.
Keep the exhaust and motor clean
Store petrol in designated containers only.
Only refuel in open air.
Replace a damaged petrol tank and/or tank
cap.
Only replace damaged or worn parts by ge-
nuine spare parts.
Subject to changes in design and configura-
tion.
No one should be standing in front of the de-
vice and/or tiller blades when starting the mo-
tor - the tiller blade drive must be turned off.
When attaching and removing the transport
wheel and/or when adjusting the depth skid,
the motor must be turned off and the tiller bla-
des must be upright.
When moving the device using the attached
transport wheel, turn off the motor and wait
for the tiller blades to come to a standstill.
The device may only be operated by main-
taining the safety distance provided by the
handlebar.
Always operate parallel to the slope.
441542_b
Do not operate the device up or down the
slope, as well as on slopes with a gradient of
more than 10°.
Do not open the tank cap or refuel with petrol
while the motor is still running and while the
machine is still hot.
Use a funnel or a filler pipe when refuelling so
that no fuel is spilled on the engine, the deck
or the ground.
Do not start the engine if petrol has over-
flowed. The appliance may be cleaned, and
any attempt at ignition may be made, only
when the petrol vapours have dissipated.
For safety reasons, never use the engine with
worn or damaged parts. Such parts must al-
ways be replaced, not repaired. Use OEM
spare parts. Spare parts of inferior quality can
damage the engine and endanger your safety
Renew exhaust silencers if damaged.
Do not change the engine governor settings.

STARTUP

Only start up the machine, after assembly is fully
completed.
CAUTION!
Fill with oil and petrol before initial start-
up. For this purpose, consult the sup-
plied operating instructions from the pe-
trol motor manufacturer.
Setting-up of Handle Height
Set-up handle height according to your proper
body size.
Common setting-up of height corresponds to
haunch height.
Loose screws on cover support.
Set-up handle height according to long holes.
Tighten screws.
Transport wheel
Motor cutter can be transported to given place by
means of transport wheel.
If you will operate the motor cutter, remove the
transport wheel or fix it into upper grip .
Engine Start
When starting the motor, the tiller blade clutch le-
ver may not be activated.
13