Publicité
Les langues disponibles
Les langues disponibles
Adjusting the traverse
Adjusting the way the carriage slides on the rail
(SEE FIGS. 7a & 7b).
- This operation requires a No. 4 Allen key and a flat No. 13
spanner.
- Adjustment is made in the horizontal plane by tightening
eccentric screws H and in the vertical plane by tightening
eccentric screws I
- To adjust the eccentric screws: place the Allen key in
the screw's hexagonal hole and use the flat spanner to
loosen the tightening nut J slightly. Tighten the eccentric
screw with the Allen key until the bearing is adjusted
correctly. Retighten the nut and check that the carriage
slides correctly.
Retighten the two eccentric screws in the
!
same plane at the same time.
To set the vertical plane, pass the Allen key on
the one hand through the height-adjustment
plate (24) and on the other through the hole
behind the switch.
Important advice
• Tighten the nuts and bolts regularly.
• When storing the machine, we recommend removing
the blade and storing it carefully.
• Check that there is sufficient water supply during
operation.
• Tighten the blade firmly.
• Make sure the contact faces of the flanges, blade and
axle are clean.
The manufacturer declines all responsibil-
!
ity for loss or damage resulting from misuse
or any modification, alteration or powering
that does not conform to the manufacturer's
original specifications.
The noise level of this machine is measured
according to the S 31.069 standard.
At the work station, the sound pressure level
may exceed 85 db (A) In this case individual
protection measures must be taken.
Repairs
S
Contact your supplier who is entirely at your
A
service to carry out repairs in the shortest time
V
at the best possible price.
Operator's manual - TS 100 R
Spare parts
For rapid delivery of spares and in order to avoid any
wasted time, it is necessary to remind your supplier of the
details shown on the instruction plate on the machine
with each order, as well as the reference of the part to be
replaced.
00000000
Item number Code
Item number Code
Scrapping
In the event of deterioration and scrapping of the
machine, the following items must be disposed of in
accordance with the requirements of the legislation in
force.
Main materials
• Motor : Aluminium (AL), Steel (AC), Copper (CU), Polya-
mide (PA)
• Machine : Steel sheet (AC), Cast iron (FT)
The instructions for use and spare parts found in this docu-
ment are for information only and are not binding. As part
of our product quality improvement policy, we reserve the
right to make any and all technical modifications without
prior notice.
(0)
Quantity
Quantity
English -
19
Publicité
