Di4 Vapore Stiro Duo 2600 Mode D'emploi page 18

Insert the main plug into the wall socket. The indicator light will turn on.
When the indicator light goes out you may start ironing.
WATER TANK FILLING
Unplug the iron before filling the water tank.
The device is designed for use with tap water. If the water in your area is hard or semi-hard use mix tap water
with distilled or demineralized water purchased in stores, in the ratio 2:1 and 1:1 respectively (distilled water: tap
water). Check with your water supplier to determine the type of water in your area. Never use 100% distilled or
demineralized, rain water, softened water, scented water, water from other appliances such as refrigerators, air
conditioners, dryers or other types of home water preparation water.
Open the cover for filling.
Slowly pour water through the water inlet.
Do not fill higher than mark on the water tank, in order to avoid spilling out of water.
The water tank should be emptied after each use.
SPRAYING
As long as there is enough water in the water tank, you may use the spray button at any temperature setting during
steam or dry ironing.
Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
Set the temperature control dial to the desired position in accordance with the manufacturer's label.
Set the variable steam control to the desired position.
CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING
The steam iron can be used on the dry setting with or without water in the water tank, it is best to avoid having the
water tank full while dry ironing.
Turn the variable steam control to the minimum position.
Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill it with water
until the steam iron cools down.
SHOT OF STEAM
The shot of steam feature provides additional steam for removing stubborn wrinkles.
Turn off the variable steam control to the min position
Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in continuously and
wait almost 5 seconds between pressures.
18