CREE LIGHTING Noctura Serie Instructions D'installation

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1
Remove the Two
Screws (on Both
Sides of Housing)
to Allow for
Attachment of Yoke
Mount.
Remove these Bolts
(on Both Sides of
Housing) to Allow for
Attachment of Yoke
Mount.
Use 1/4" Screws (Provided by
Others) Here, to Fix the Bracket
to the Mounting Surface
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
registered trademarks of Cree, Inc.
1 of 1
IMPORTANT SAFEGUARDS
Button Photocell
(Ordered Separately)
Mounting Bracket
Thread Lead Here
and the Cree logo are
®
Noctura Series
LED Flood Lights
Small Flood Yoke Mount Accessory
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
YOKE MOUNT- REQUIRES USE OF
NTF-YM ACCESSORY APPROPRIATE
FOR HOUSING SIZE BEING USED
STEP 1:
Remove (2) #8 screws and (2) 1/4-20 bolts
from sides of luminaire housing. See Figure 1.
Discard screws.
STEP 2:
Attach yoke bracket to both sides of the
luminaire using (2) 1/4-20 bolts and
lockwashers supplied with yoke accessory. Do
not fully tighten bolts at this time.
STEP 3:
Aim luminaire in desired direction and attach
yoke to mounting surface using (2) 1/4" (6
mm) fasteners appropriate for mounting
surface.
STEP 4:
Tilt luminaire to desired angle. Lock tilt angle
using the #8 screw (included with yoke)
threaded into the housing on either the left or
right side of the yoke. Tighten screws to
20 in-lbs (2.2 N·m).
NOTE: Notches on the two legs of the
yoke allow for locking at tilt angles in 15°
increments. Notches on one leg of the yoke
lock luminaire at 0°, 30°, 60°, or 90°, while the
notches on the other leg lock the tilt angle at
15°, 45°, or 75°.
STEP 5:
Tighten (2) 1/4-20 yoke bolts to 72 in-lbs
( 8 N·m).
www.creelighting.com
LPN00629X0002A0_B